Description
- The Summa Pneumatic Oscillating tool is capable of cutting materials up to 25mm thick. It is ideal for cutting thick materials like honeycomb board, corrugated cardboard and foam boards, as well as some soft foams and rubbers.
- The pneumatic oscillating tool (POT) is powered by compressed air and moves the knife up and down over a stroke of 8mm with a maximum frequency of 150Hz.
- Cuts materials up to 25mm thick.
- Speed adjustments allow for some soft foams and rubber to be cut.
Specifications
- Pneumatic Oscillator with Gliding Disk
- 1 Knife (20 x 0.65mm) with hex key
- Pneumatic Kit, including Pneumatic Oil and Oil Mister
- Stroke: 8mm*
- Frequency: 150Hz*
- Compressed Air Requirements: 6bar & 78l/min.
- Summa recommends having a compressor that has 4-5 times the airflow capacity: +/- 360l/min
* The Stroke and Frequency may drop depending on the load on the tool.
Note: Air-compressor not included.